Phobya Variable SLI/Crossfire VID Connection Nipple G1/4 - 1 Slot

The Phobya Variable SLI/Crossfire VID Connects two that are operated in a system in SLI mode. The special feature of this fitting is that it varied by about 12mm adjustable in length.

Therefore, these nipples are used with graphics cards from different manufacturers. The nipple can be used either for the graphics cards to run in series, or if you set two nipple between two graphics cards, so both can be cooler when run in parallel. This is of course also possible with 3 graphics card coolers. SLI is the connection nipple is available in 3 lengths:

Article 64 095 for a slot
Article 64 096 for 2 slot
Article 64 097 for 3 slot mainboard.

• A direct connector between two graphics cards.


• Thread: G1 / 4


• Material: brass, black nickel


• Distance between the coolers: 18.9 to 30.3 mm


• Suitable for motherboards with a slot gap between the two graphics cards.


• Suitable for VGA crossfire of eg Ek Water Blocks Koolance, DangerDen, XSPC, Alphacool OTC-Flat

The nipple is only compatible with graphics cards, the top and bottom of each of two G1 / 4 inches thread. With the coolers have only connections on one side (eg Aquacomputer) can not be mounted to the nipple.