Acrylic
StealKey Customs SK-Crosscool III Lian Li O11 DYNAMIC EVO RGB Distroplate D-RGB
SK-SW10160
Thank you for your submission!
We will get back to you soon.
Estimate shipping
1 in stock
$315.99
/
Shipping calculated at checkout.
Pickup available at Performance-PCs.com
Usually ready in 1 hour
Details
Details
The SK-Crosscool III Lian Li O11 DYNAMIC EVO RGB Distroplate D-RGB is a distro plate, reservoir, and pump solution in one. It fits the front of the Lian Li O11 Dynamic EVO RGB case.
High-quality materials
Only brand-name acrylic is used to manufacture the distroplates. The material is machined on precise machines in the Stealkey Customs facility. M3 stainless steel screws are also used to assemble the distroplates. Powder-coated sheet steel conceals the D-RGB stripes on the side, which are still soldered by hand.
Reverse Mode
The Crosscool 3 allows you to invert your configuration. The Lian Li O11 DYNAMIC EVO RGB case can be mirrored if needed. This allows you to view the graphics card and motherboard from the right side panel instead of from the left.
Ideal for CPU and GPU water blocks
A total of nine ports allow for the connection of a vertically or horizontally mounted GPU cooler. Six of these ports are for input and three for output. Their spacing is designed so that the graphics card cooler can be connected directly to the connectors on the distribution plate, regardless of the PCI slot in which the graphics card is installed. Two additional ports, spaced 28 mm apart, allow for a CPU cooler to be connected directly to the distribution plate.
Compatible radiators
The distro plate supports up to 3x 360mm radiators, allowing you to take full advantage of the case's size and unleash the full potential of your hardware components.
With the distro plate installed, the maximum radiator thickness is as follows:
Top: HEATKILLER RAD 360-L (48 mm) Bottom: Maximum HEATKILLER RAD 360-L (48 mm) (Radiator ports on the side of the distroplate, for direct connection, without tubing over the fan) Side: HEATKILLER RAD 360-L (48 mm)
Pump bracket for D5 and DDC pumps
We use a proven principle for mounting the Xylem Lowara D5 and DDC pumps. A custom-made adapter is attached to the distroplate. A D5 ring made of POM is slipped over the D5 pump and then secured to the adapter. The DDC pump, however, can be attached directly to the adapter. M4x25 mm screws are required for this (available separately in the shop). The result is a universally usable distroplate, suitable for both D5 and DDC pump enthusiasts.
Easy installation of the Distroplate
The Crosscool III is mounted with four screws on the front of the case, directly behind the front panel. Two screws at the top and two screws at the bottom ensure perfect hold. These screws fit precisely into the existing mounting holes in the case, making installation particularly simple and user-friendly.
Addressable D-RGB lighting
To give your setup that extra something, we've naturally included D-RGB lighting. It connects to a 3-pin 5V header on the motherboard. A powder-coated steel strip conceals the individual spots on the RGB strip, allowing a uniform band of light to illuminate the distro plate and its coolant.
Important NOTE
- Compatible only with the Lian O11 Dynamik Li EVO RGB case.
- Mounting screws for the DDC pump must be purchased separately.
- The DDC pump or D5 pump is water-lubricated and must not run dry, otherwise permanent bearing damage may occur.
- Screw fittings into the Distroplate only hand-tight (0.7-1.5 Nm). Do not use alcohol-based cleaners. Danger: Acrylic may crack.
Features
Specifications
