Swiftech 500 Coolsleeves - UV Green

Coolsleeves ™ are extruded PVC coils designed to be wrapped around soft vinyl and thin wall tubes, to eliminate tube kinking and flattening in medium to sharp bend areas.

Coolsleeves ™ are available in two different sizes:

• Coolsleeves ™ 500 for 1/2 OD tubing
• Coolsleeves ™ 625 for 5/8 OD tubing

Each size is available in 4 different colors: clear transparent (non UV reactive), Horizon blue (UV reactive), Saturn Green (UV reactive), and Red (non UV reactive)

Coolsleeves ™ are shipped in precut 40 length. One length is typically sufficient for a single CPU cooling circuit depending on how tight the coils are wrapped around the tubing. Two lengths are necessary for a complete circuit including dual CPU, CPU+VGA, or CPU+VGA+Chipset setups.

The advantages of Coolsleeves™ coils are multiple:

1. Performance:

• Coolsleeves™ coils do not restrict flow rate compared to internal springs
  

2. Reliability:

• Coolsleeves™ coils completely eliminate flattening of the tubes over time


• Coolsleeves™ UV reactive coils are a safe alternative to UV reactive coolant dies and prevent the pump failures caused by these dies.


• Coolsleeves™ coils allow to bend soft vinyl and Tygon tubing at sharp radii without kinking. The sharpest possible radius is achieved by spacing the coils close to each other (3/16):
  
  
  
  • Minimum bending radius for 1/2 Coolsleeves is 1.25
  
  
  • Minimum bending radius for 5/8 Coolsleeves is 2.5
  
  
  
  

A 1.25 bending radius is achieved here with Coolsleeves™ 500

A 2.5 bending radius is achieved here with Coolsleeves™ 625 and 5/8 Tygon tubing, with a fairly large spacing of 1/4 between coils.

A 2.5 bending radius is achieved here with Coolsleeves™ 625, and inexpensive 5/8 thin wall vinyl tubing, with the coils spaced fairly close to each other (3/16). Wider coil spacing would not prevent kinking with this type of tubing.

4. Convenience:

• Coolsleeves™ can be used with existing 1/2 OD tubing systems to reshape tubes that have flattened over time without disassembling the system.


• Coolsleeves™ 625 now allow users of 1/2 ID tubing to use thin wall 5/8 tubes instead of 3/4, for a significant reduction in clutter inside the chassis, and radii that were absolutely impossible to achieve with 3/4 tubing.

5. Cosmetics:

• Coolsleeves™ UV reactive coils are fun and attractive under UV light:

• ..Or in normal light:

6. Cost to consumers:

• Coolsleeves™ 500 coils are more economical than other solutions: the cost per foot including vinyl tubing is up to 50% less than Clearflex™, and up to one third the cost of Tygon™ tubing.