Thermaltake Pacific 1/4'' Fill-port - Chrome

Thermaltake Pacific 1/4â? (6.35 mm) Fill-port â?? Chrome

Thermaltake introduces the Pacific Series fill port fittings for the ultimate in custom PC water cooling configurations, finished in black-plated copper with a unique Tt logo. Choose from: 1/4�, 3/8�, and 1/2�, Thermaltake fittings provide a complete solution for DIY enthusiasts and PC builders by giving users ideal mounting, fitting and flow.

High-flow and Leak-free Design

Made in Taiwan, the fittings allow proper connection to G1/4� thread, securing properly to flexible tubing for easier coolant refill. The fittings are available in chrome and black finishes.

More Information

P/N	CL-W036-CU00SL-A
DIMENSIONS	â?®16 x 17.5 (H) (mm)
WEIGHT	12 g
MATERIAL	CU
NOTE	Stop to Tube
APPLICABLE	ID : 1/4�( 6.35 mm )
SCREW THREAD	G 1/4

 

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

• To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.


• Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.


• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.


• Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

 

Thermaltake recommends the following steps to be taken after completing your water loop setup

• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system â?? copper, brass, nickel, aluminum, and steel â?? from corrosion.


• Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.


• DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately


• Fill the reservoir to the top as it will prevent air from going into the pump


• If necessary tilt the system slightly from side to side to bleed the air out of the loop.


• Place some paper towels under fittings and joining points to test for leaks.


• Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.