Facebook Pixel

 

Swiftech MCP50X Exteme 12 VDC DDC Pump

Swiftech MCP50X Exteme 12 VDC DDC Pump

Alphacool Eispumpe VPP755 - Single Edition

Alphacool Eispumpe VPP755 - Single Edition - Rev.3

Alphacool Eispumpe VPP755 - Single Edition - Rev.3

SKU
AC-13294
Rating:
100% of 100

Alphacool is announcing the next evolution in pump technology with the VPP755 Eispump. This pump, technologically a completely new development, throws out all the old problems with the well-known D5 pumps and retains only the compatibility to all current D5 tops and brackets. The VPP755 Eispump dispenses with the spherical bearing and opts instead for a ceramic shaft that makes for quieter operation.

 

$62.50
In stock Low Stock 1 left
More Information on Shipping

Alphacool is announcing the next evolution in pump technology with the VPP755 Eispump. This pump, technologically a completely new development, throws out all the old problems with the well-known D5 pumps and retains only the compatibility to all current D5 tops and brackets. The VPP755 Eispump dispenses with the spherical bearing and opts instead for a ceramic shaft that makes for quieter operation. The motor’s coils are now on the outside instead of inside. All of this provides more stability, which results in less vibration. It also means the power consumption is cut nearly in half. Yet the VPP755 Eispump still boasts a 4m maximum head for higher performance. The VPP755 Eispump is also distinctly quieter than the classic, well-known D5 pump while providing the same performance.

One of the innovations of the VPP755 Eispump is its many control options. The 4-pin molex connection provides the power, and plugs directly into the power supply.

If desired, the 3-pin connection can be used to read the pump’s RPM. This can be connected to the corresponding motherboard or to a fan controller.

Through the 4-pin PWM connection, the pump can be controlled by PWM as usual. The RPM can be read through the 4-pin PWM connection as well.

On the backside of the pump there is a small rotary switch, the same as on the VPP655 Solo. This switch has 5 levels for manually controlling the pump. The unique thing here is that the manual control and PWM control can now work together – a system patented by Alphacool. Using the rotary switch, the general maximum RPM for the pump can be set, which then cannot be exceeded by the PWM control. Practically, this means that if the pump is set to level 3 with a maximum RPM of 3200, you can also only reach a maximum RPM of 3200 through the PWM control.

Now every user can set exactly how the pump should run, and in what RPM range, even if the PWM control on the motherboard or fan controller has few settings.

Visually, some changes have also been made. The VPP755 Eispump is about a centimetre shorter than the classic D5 pump and has an aluminium cap. The pump looks elegant and fits perfectly into a modern system.

The Alphacool VPP755 Eispump is an improvement over the classic D5 pump VPP655 in every respect. In no area is it weaker or louder than its predecessor, and it offers new options for controlling the pump according to your wishes.

Note: *Will NOT fit tops made before 2011. Impeller is not made to be removed from its axis.*

   *Boxes Will Say Rev.2 But You Are Getting The Rev.3*

Approved fluids: Water, Water/ glycol mixture
Color: Aluminium grau eloxiert
Dimensions: 60 x 60 x 53,5 mm
Manufacturer: Alphacool
Material: Aluminium, Ceramic, Plastic
Max. Discharge head: 4m, Good (2 to 4m)
Max. Flow: 350l/h, Standard (smaller than 500l/h)
Max. System temperature: 65° C
Possible control range: 8-13V DC
Power connector: 4Pin Molex
Power input: 14W
Voltage: 12V DC
Water inlet: Not available
Water outlet: Not available
  • Dimensions (DxH): 60 x 53,5mm
  • Cable length: 50cm
  • Standard voltage: 12V DC
  • Power consumption: 14W
  • Accepted voltage: 8-13v DC
  • Pressure at 12V: 4m head
  • Maximum flow: 350l/h
  • Pump fluid: water, water/glycol mixture
  • Maximum system temperature: 65°C
  • Power connection: 4-pin Molex
  • Speed sensor signal: 3-pin
  • PWM signal: 4-pin
  • Special features: adjustable to five levels
    • Level 1: 1800 RPM
    • Level 2: 2500 RPM
    • Level 3: 3200 RPM
    • Level 4: 3900 RPM
    • Level 5: 4500 RPM

Scope of Delivery

  • 1x Alphacool Eispumpe VPP755 - Single Edition

Note: *Will NOT fit tops made before 2011. Impeller is not made to be removed from its axis.*

*Boxes Will Say Rev.2 But You Are Getting The Rev.3*

 

Notice
Not intended for continuous operation with fluids containing titanium dioxide or glycerin. Many pastel colours typically use these additives.

 

NOTE
Should the pump begin to rattle while in operation, loosen the retaining screws on the pump by a quarter- to half-turn. Due to the very closely measured tolerances, the impeller in a pump that is too tightly screwed on can start to knock against the pump lid.

 

CAUTION
Removing the impeller from the ceramic shaft will cause the upper clamping ring to over-expand, which will destroy it! Removal will void the pump’s warranty!

 

If the pump is put together again and put back into operation, the clamping ring will loosen, which is not accepted as grounds for a return or exchange...

 

NOT compatible with Monsoon and Primochill reservoirs

 

Notice:

Attention: The manufacturer Mayhems advises that Mayhems fluids, especially the Aurora line of products, have been manufactured and distributed solely for show and modding purposes. These should not be utilized in the system for more than 14 days.

 

We would also like to advise that Mayhems fluids can damage water cooling products, and using Mayhems fluids can thereby void the warranties offered by the following manufacturers: Koolance, Phobya, Alphacool, Aqua Computer, Watercool.

 

Damages such as: clogging, corrosion of aluminium radiators, deterioration of glued containers, etc., are a consequence of the use of Mayhems, but will not be reimbursed by Mayhems. Use is therefore at one’s own risk.

 

There are definitely a lot of positives here- as a Laing D5 alternative especially. Be it the better looking aesthetics from the pump cover to sleeved cables or the shorter form factor coupled with a much better performance/noise ratio. Alphacool should be rightly proud of this product. I leave here very impressed, and hoping that other companies continue to develop their own solutions than relying on a company that seems to care less and less about PC watercooling.

Click "HERE" to read more!
==========================================================================================
Oct 31, 2016
Extreme Rigs
"From our time with the VPP755 we think that Alphacool are onto a winner. It certainly has a few issues with the control system, however the finish and performance are above and beyond the competition. The presentation of the VPP755 is hands down the best on offer with a slick painted finish on the cover which has even been laser etched and the sleeved wires make a very professional and impressive looking pump."
Read the Full Review--> HERE<--

erlogosilvernew4

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

Questions & Answers

Search Q/A
Sort by
Expand All +
pdf
VPP 755.pdf (284.55 KB) Download
Download PDF Download PDF
We found other products you might like!
Recently Viewed
No recently views items
Clear All
Please select a wishlist