Tecnofront Micro Trap Reservoir - 1/2"
New header tank from the house Tecnofront. This is manufactured complete from Plexi and offers to that extremely optical responding Design also still some constructional refinement this header tank other one ahead-has. He can be installed at the back of the housing inside and/or outside as completely special Hingucker. Exactly the same one could install it lying on the ground. Thus that the complete header tank from Plexi is manufactured, can one see always exact like much coolant is still present. A further really unusual highlight on the construction is a channel on the inside, which for it provides that the cooling agent only the complete AGB flow through must to it on the other side is again sucked in. That is besonderst with the ventilation an important point, since the bubbles from the system are not sucked directly again into the cycle. For filling the AGB´s only a screw provided with an O-ring must be loosened and then can one the system very easy fill. One very well solution is also the retaining principle. Not as with other manufacturers it is fastened over clips, no, here is connected with the AGB, likewise complete the mounting plates from Plexi. This offers additional stability and is also the risk to 0 set a clip to break off can.
- Material: Plexi
- Measures outside (L x B x H): 105mm x 68mm x 41mm
- Weight: approx. 300gm
- Connection: 2x thread G 1/4" - 1/2"
Scope of supply:
- 1x header tank
- 2x 13mm of hose connectors
Note: The product is supplied without connections!