MIPS ASUS Maximus 4 Fullcover POM
Limited Nickel POM black Edition !!! This Fullcover Block was developed for the following ASUS Motherboards: - ASUS Maximus 4 Extreme P67
Limited Nickel POM black Edition !!! This Fullcover Block was developed for the following ASUS Motherboards:
- ASUS Maximus 4 Extreme P67
On this Mainboard the Southbridge, NF200 Chip as well as the MOSFET modules are cooled by one Heatpipe. This Heatpipe works only in combination with very large CPU coolers. Should you cool your CPU with a water block there is not enough air to cool the heatsinks properly.
With our new Fullcover water block it is possible to cool the Southbridge, NF200 Chip and the Mosfets with one water block, offering the following advantages:
- No more fittings in the graphics card area, hence allowing full utilization of all expansion bay slots.
- Only 2 G1/4" fittings of your choice are needed, even very large fittings are no problem. Thanks to the large spacing between the connection threads the water block is also perfect for High-flow fittings
- Not only the two Chipsets as well as the Mosfets are being cooled, but also additional heat-critical components are cooled. To achieve this, the cooling plate is milled at four different heights
- To prevent stress on the Mainboard in the area of the voltage regulators this water block is shipped with a back plate made from solid copper
- The backlit R.O.G. logo can be removed from the stock heatpipe and be put back into the fullcover water block (The cable is routed under the water block)
If you are already using a water cooling system, this is the perfect expansion for your system.
IMPORTANT: Removal of the stock heatsink may result in a loss of warranty, hence please work accordingly careful when installing this product. We accept no liability for damages respectively consequential damages!
Hint: For the Mosfets please use the included thermal pads, for the back plates the included rubber sheets! For the Southbridge as well as the NF200 Chip please use an electrically non-conductive thermal compound such as the Arctic MX series as well as our protective pad MCH0352 for protection of the Southbridge!
Overall size without fittings: 245 x 126,5 x 27mm (L x W x H without fittings)
Cooling plate: Pure copper 5mm (Mosfet), 3mm (Chipsets)
Top plate: POM black
Connection thread size: 1/4"
The water block is shipped without fittings, please order separately if needed!