XSPC Acrylic/PETG Easy Cut / Easy Bend Toolkit

The Acrylic/PETG Easy Cut / Easy Bend Toolkit, takes the hard work out of using rigid tubing. These kits are made for tubing with 10mm inner diameter and 12-14 outer diameter. Just follow these simple steps:

1. Insert the Bending Rubber into the acrylic/PETG tube
2. Heat the tube at the bend point, using a heat gun or hair dryer (not supplied)
3. Insert the heated tube into the acrylic/PETG Easy Bending Tool
4. Bend the tube to the required radius and allow to cool
5. Remove the Bending Rubber from the tube
6. Use the Heavy Duty Hose Cutter to trim the tube to the required length
7. Insert each end of the trimmed tube to the acrylic/PETG Chamfer tool and rotate anticlockwise
8. Use the Sand Paper to clean up the chamfered edges

** NOTE" Silicon bend chord can shrink by nearly 4% with drops in the temperature from 35C to 15C. On a loose fit in your tube, XSPC's advises customers to soak the chord in warm water before use.