Alphacool Silicon Bending Insert 100cm for ID 1/2" / 13mm hard tubes - blue

The perfect solution for perfect curves in the Alphacool HardTubes is now available.

Simply slide the silicon insert into the plexiglass tube and heat up the desired section. Thanks to the extreme heat resistance of silicon, the tube can be bent without the curved section buckling. After it cools, the silicon insert can simply be pulled out.

Available for tubes with 10mm, 12mm, and now 13mm inner diameters, and each size comes in 30cm length for curves in shorter tubes or 100cm length for curves in longer tubes.